Installation Sheet
PAGE 5
4409BF_FTN_A LK4409BF_FTN_A
1000004377 (Rev. B - 07/18)
ITEM
NO.
PART NO.
ITEMIZED PARTS LIST
DESCRIPTION
1000003814*
45931C
1000003813*
55996C
1000004372
98686C
97247C
98678C
98733C
98680C
98681C
1000003692
1000003693
98682C
1000003694
1000003695
98683C
98685C
1000004374
40251C
28467C
97446C
98679C
98684C
1000004373
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
Cover - Round Plate
Outdoor Bottle Filler Drain Plug
Bottom Cover
In - Line Strainer (See rough-in location on page 3)
Tube - Drain (Formed)
Kit - Bottle Filler Waterway/Gasket/Nipple/Tubes/Ftngs
Kit - VR Torx Screws/Bit
Kit - 1.0 GPM Regulator/Holder/Nut (BF Only)
Kit - Regulator/Holder/Nuts
Kit - Aerator/Key
Kit - Blank Bottle Filler Trim
Kit - LK4409 Bottle Filler Trim
Kit - 4409 Bottle Filler Trim
Kit - Push Button w/Blank Nameplate
Kit - Push Button w/LK4409 Nameplate
Kit - Push Button w/4409 Nameplate
Kit - Drain Adapter/Gasket/Nut/Washer
Kit - Hardware/Bolts/Nuts/Washers/Torx Screws
Tube - Drain
Drain Tail Pipe (Straight)
Basin
Kit - Bubbler (VR)
Kit - Nozzle/Aerator/Gasket/Pin
Kit - Drain Elbow/Gasket/Nut/Washer
Tube - Drain
PRINTED IN U.S.A.
Halsey Taylor – halseytaylor.com
Elkay – elkay.com
FOR PARTS CONTACT YOUR LOCAL DISTRIBUTOR OR CALL TECHNICAL SERVICES AT 1.800.834.4816
2222 CAMDEN COURT, OAK BROOK, ILLINOIS 60523
*select color option to complete part number
*FINISH COLOR OPTIONS – Choose color option to
complete your model number, add as sufx example:
4409BFEVG
Matte nish: Evergreen = EVG
Gloss nish:
Beige = BGE Gray = GRY Terracotta = TER
Black = BLK Orange = ORN White = WHT
Blue = BLU Purple = PUR Yellow = YLW
Brown = BRN Red = RED
FIG. 4
STREAM HEIGHT ADJUSTMENT:
Stream height is factory set at 35 psi. If supply pressure varies greatly
from this, insert a small straight bladed screwdriver through the access
hole in the center of the push button and turn the adjustment screw.
Clockwise adjustment will raise the stream and counterclockwise ad-
justment will lower the stream. For best adjustment, the stream should
be approximately 1 1/2" above the top of the bubbler.
Vandal-Resistant Bubbler
FIG. 3
18
BASIN