Installation Sheet

[phone] 9 Elkay Manufacturing Company
Installation Manual (1000005449 Rev. A) In-Wall Filtered Water Dispenser
4. Replace the lter unit cover and check the gap
between the two covers. Adjust the lter box to create
an even gap all the way across the units. Tighten all
screws.
Create an even gap across the entire unit.
Note: Some side-to-side and up-and-down movement of
the housing is possible to accurately align the filter
unit with the water dispenser.
5. After aligning the two sections, remove the front cover
from the lter unit by removing the four at head
screws from the right and left side of the cover using a
3/32 Allen wrench.
6. Route a 1/4" water line from the water dispenser into
the lter housing outlet (located on the underside of
the lter head).
NOTICE
Do not disconnect the 1/4"
tubing from the water valve at
the top of the water dispenser. This connection has
been factory tested to be leak-free and could result in
water leaking into the unit if this connection is
changed.
7. Connect the NFC wire to the wire harness.
8. Connect the 1/4" tube to the tting below the lter, as
shown.