Installation Sheet

Elkay Manufacturing Company 14 [phone]
In-Wall Filtered Water Dispenser Installation Manual (1000005449 Rev. A)
5. Startup
1. Open the shutoff valve(s) for the water supply. Check
for any water leaks.
2. Remove the scratch-resistant protective layer that is
covering the glass face, the lter cover (if used), and
the back wall of the water dispenser.
Note: Not removing the back wall covering layer will
activate the IR sensor when the unit is turned ON.
3. Place the ON/OFF switch in the upper left-hand corner
of the water dispenser opening in the OFF position.
Turn the power to the unit ON (typically a circuit
breaker).
4. Move the power switch to the ON position and make
sure the LED lights are lit.
5. Place a container under the water dispenser spout
to activate the ll sensor and dispense at least one
gallon of water to bleed off any trapped air from the
supply lines and lter as well as ush any ne carbon
particles from the lter.
Note: The water dispenser is set to automatically shut off
after 16 ounces of water has been dispensed to
prevent overow and potential ooding so multiple
activations will be required to get the required one
gallon of water ow through the unit.
6. If there are no leaks and the unit is functioning
correctly, install the water dispenser's glass front cover
and then install the lter box cover (if used) using the
athead screws and a 3/32" hex wrench.
7. Upon initial startup, the PLASTIC BOTTLES SAVED
indicator panel should show several bottles have been
saved due to the water used to initially start up the
unit.
8. The left-most FILTER LIFE indicator light should also
be lit. This light shows the lter is functioning correctly
and has used less than 65 percent of its capacity.
When the middle blue light illuminates, the lter has
reached 66 percent of its life and will need to be
changed soon. When this indicator light comes on, a
replacement lter should be ordered.
9. The right-most light will illuminate in red and indicates
that the lter should be changed.
FILTER LIFE PLASTIC BOTTLES SAVED
10. Once the installation is complete, the water has been
turned on, and any trapped air has been bled from
the system re-check for any water leaks.