Installation Guide

Elkay Manufacturing Company 12 [phone]
Built-in Filtered Water Dispenser 1000005232 (Rev. C - 05/19)
6. Attach one end of the 3/4 inch exible drain hose to
the 3/4 inch barbed drain adapter connection using the
supplied hose clamp. The supplied exible drain is 13
inches long. If a longer drain hose is required, it must
be installer-supplied.
7. Place the drain basin back into the water dispenser
and reinstall the two screws.
8. Route the drain hose through the lter box and
attach the other end to the p-trap drain adapter using
a hose clamp. The drain adapter is designed to be
glued into a 1-1/4 inch PVC pipe.
9. Install the lter.
10. Connect the drain adapter into the household waste
drain pipe.
If the p-trap is located inside a sealed walled, it must
have permanently-glued joints. If the p-trap is in an
accessible location, a standard non-glued p-trap is
acceptable.
Note: Whichever installation method is used, it must
meet local standards and building codes.
11. Install metal cover. Do not install the drip tray if the
unit is plumbed into the household waste line.
4.7 Remote Filter Location
The lter unit can also be installed remotely, up to 15 feet
away from the water dispenser. The remote lter location
is normally associated with the installation of a water
chiller.
1. If desired, remove the lter unit from the lter box.
2. Securely mount the lter unit in the desired location.