Installation Guide

[phone] 11 Elkay Manufacturing Company
1000005232 (Rev. C - 05/19) Built-in Filtered Water Dispenser
1. Remove the two screws attaching the drain basin to
the water dispenser. Remove the drain basin.
2. Place the drain basin on a at, hard surface, such
as a piece of sacricial wood. Carefully drill a hole
in the basin using a 1-inch hole saw using the
centering-dimple as a guide to center the hole saw.
Note: Do not use a 1-1/8 inch hole saw as this will make
the opening too large.
3. Place a small amount of plumbers putty around the lip
of the strainer ange and insert it into the hole. If the
ange does not t, carefully open the size of the hole.
4. Install the O-ring over the strainer threads.
5. Thread the strainer into the drain adapter.
Needle-nose pliers can be used to turn the drain
adapter. Tighten the connection to create a watertight
seal. The drain adapter must be facing to the left.