Installation Guide

[phone] 9 Elkay Manufacturing Company
1000005232 (Rev. C - 05/19) Built-in Filtered Water Dispenser
NOTICE
It is recommended to attach the
front cover with the top two
mounting screws to prevent it from falling away from
the water dispenser while the lter unit is being
installed.
2. Place the lter unit into the wall opening and slide it up
against the bottom of the water dispenser. Make sure
the lter unit is in alignment with the water dispenser
and, using four #8 athead screws, start the screws to
hold the unit in place.
Do not completely tighten the screws until the lter
unit cover is installed and the t between the water
dispenser cover and the lter cover is checked.
Note: Some side-to-side and up-and-down movement of
the housing is capable to accurately align the filter
unit with the water dispenser.
3. Replace the lter unit cover and check the gap
between the two covers. Adjust the lter box to create
an even gap all the way across the units. Tighten all
screws.
Create an even gap across the entire unit.
4. After aligning the two sections, remove the front cover
from the lter unit by removing the four at head
screws from the right and left side of the cover using a
3/32 Allen wrench.