Installation Sheet

0000001059 (Rev. B - 10/14)
EZWS-ERPB8-RF LZWS-ERPB8-RF
Page 4
Figure 6 – LZWS-ERPB Tube Routing
CHILLER
INLET
CHILLER
OUTLET
8
STRAINER
TO BUBBLER
Figure 5 – EZWS-ERPB Tube Routing
TO BUBBLER
8
UNION
8
CHILLER
OUTLET
WATER
INLET
8
8
TO BOTTLE
FILLER
TO BOTTLE
FILLER
4. (For LZWS-ERPB8-RF) If an existing lter is not present,
install lter bracket on chiller (Fig 4), then install the lter head to
the bracket, plumb from the lter outlet to the chiller inlet with ¼”
poly tubing and ¼ x ¼ union, install lter.
5. (For EZWS-ERPB8-RF) Verify that a strainer is installed on the
water supply line to the chiller (Fig 11).
6. Install chiller on shelf, install ¼ x ¼ x ⅜ tee on chiller output
tube. With the back panel standing close to the frame, connect
⅜” poly tube from the bottle ller to the chiller outlet tee.
7. Install reset switch for bottle ller (Fig 7). Connect the switch
wire to the extension wire on the back of the bottle ller. Wrap up
the excess cord.
8. Hang main panel on mounting frame hanger. Make sure the
power cord, reset switch wire & poly tube do not get pinched
between the panel & mounting frame. Ensure the panel en-
gages at the top. Align fountain holes with mounting frame
holes.
9. Remove protective coating from main (upper) panel.
Figure 4 – LZWS-ERPB8-RF Filter Mounting
(not required with EZWS-ERPB8-RF)