Installation Sheet

EZWS-ERPB8-RF LZWS-ERPB8-RF
0000001059 (Rev. B - 10/14)
Page 3
Remove left hand mounting frame, replace with new open frame (included).
BOTTLE FILLER / FOUNTAIN RETRO-FIT CONVERSION
REQUIRED TOOLS AND MATERIALS
These tables show special tools and/or additional materials
(not provided) which are necessary to complete installation
of these units:
Tools Not Provided
Description
Quantity
Safety Glasses
Gloves
Electric Drill / 5/32” Bit
Wrenches, Crescent Wrench,
Channel Lock Type Pliers
5/16” Nut Driver
Hammer / Center Punch
Sockets & Ratchet Wrench
1
1
1
1
1
1
1
1
1. Prepare for conversion. Turn off electrical power and water
supply to existing installation.
2. Disassemble the current installation see (Fig 2).
• Remove existing fountains and plumbing connection lines.
• Remove upper and lower panels
• Remove left hand mounting frame
3. Install new mounting frame into left hand side of wall opening.
• Secure mounting frame to wall opening and adjacent frame.
• Use all fastener holes to secure the frame properly.
Additional Materials Not Included
Item
Description
Quantity
Unplated copper inlet pipe
Service Stop/Shut-off Valve
90° 1-1/4” Drain Line
1-1/4” Tee Drain Line
1
2
3
4
1
1
2
1
Typical current installation with fountains and panels removed.
Disassemble current Bi-Level Refrigerated fountain installation
Figure 2
Figure 3