Instruction Manual
Page 42000000557 (Rev. B - 06/22)
LZO8WSN_2A
Operation: Start-Up
Figure 6
BOTTLE FILLING UNIT
WALL MOUNTING PLATE
1.
holding top cover to Bottle Filler (see Fig 3). Remove top cover.
reinstall top cover.
2. Remove wall mounting plate from Bottle Filler. Place wall plate
against wall on top of basin. Center the wall plate side to side with
3.
4.
obround mounting holes (mounting bolts not included)
5.
(10mm) tube, but do not discard. Feed the power cord (not provided)
prevent scratching the basin place a towel or soft cloth over the
entire basin when working above it.
6.
bracket & (2) screws (See Fig 5).
basin gasket (See Fig 4).
8.
wall and line up top cover two (2) holes.
1.
2.
WARNING
3.
•
NOTE:
4.
5. Replace the lower panel ensuring that the metal wrapper is secured inside of the
6.
Filler and unit into wall. Be sure to reinstall fuse to the circuit or switch the circuit
8.
purged from the line.
9.
for use.
Installation: Bottle Filler Mounting
Figure 2 Figure 3
Figure 4
29
Figure 5
9. Reinstall Top Cover on Bottle Filler (See Fig. 3) with two mounting screws from step 1 above.
Caution: Do not over tighten screws.
10.
11.
98568C is used on single cooler unit, the cooler is no longer
ADA compliant.
12.
Installation: Electrical connection
1.
BLK
COLD CONTRO
L
GND
FA N
WHT
RED
SENSOR
W
H
T
BLK
23
1
5
6
M
S
C
3
1
2
SOLENOID
VALV E
GREEN
RELAY
MALE TERMINAL ON
WHITE SHORT LEAD
ON POWERCORD
GND
GND
OVERLOAD
EMI FILTER
C
OMPRESSOR
Wiring Diagram
12