Installation & Assembly

STEP ONE
Place sink upside down on countertop surface.
Place sink in exact position for installation
and pencil completely around sink to create a sink
outline.
STEP TWO
Scribe actual opening 5/16 ” inside the sink outline,
all the way around.
STEP THREE
Cut out on inside of this line. Cut hole straight
down through top - you ’ll do a better job. If sink
comes with a faucet deck, install faucet to sink and
tighten.
STEP FOUR
Apply a sealer around entire perimeter of opening.
Set bowl into opening.
STEP FIVE
From underside of sink, place one clamp near
center, tighten by hand enough to hold sink in
place. This applies to all four sides. Fasten balance
of clamps in position and hand tighten. (Usually 3
clamps on end, balance divided equally front and
back). Space clamps as equally as possible.
STEP SIX
From the top side, check seal between rim and
countertop. Adjust clamps to high spot if necessary.
STEP SEVEN
Tighten clamp evenly with scr ewdriver or socket
wrench in rotation until sink is perfectly seated with
countertop. Caution: Do not overtighten clamps as
it is not necessary for a perfect seal.
I I
. Self Rim Sinks
1
POSITION SINK ON
COUNTER UPSIDE DOWN.
4
DRAW LINE AROUND SINK.
DRAW LINE 5/16" INSIDE SINK OUTLINE.
CUT ON INSIDE LINE.
5/16"
SINK
SINK OUTLINE
1-1/2" RADIUS
APPLY SEALER
AROUND CUTOUT.
2
3
COUNTERTOP
SEALER
CLAMP DEVICE FOR RECTANGLE AND SQUARE
STAINLESS STEEL SINKS
SINK
7
5 6