Specification Sheet

WALL HANGER
12" X 1"
(305mm X 25mm)
(FURNISHED LOOSE)
11/16"
(17mm)
29-1/2" (749mm)
WALL OPENING
1"
(25mm)
1/8"
(3mm)
4-11/16"
(119mm)
4-1/4"
(119mm)
4-1/4"
(119mm)
4-11/16"
(119mm)
7 MOUNTING HOLES
FOR 1/4" (6mm) DIA. SCREWS
17" (432mm)
WALL OPENING
5-3/4"
(146mm)
5-3/4"
(146mm)
WALL CUTOUT
WITH BOLT LOCATIONS
FOUNTAIN
LOCATION
40" (1016mm)
RECOMMENDED HEIGHT
FROM FLOOR TO RIM
OF FOUNTAIN
34" (864mm)
FLOOR TO RIM IF
REQUIRED TO COMPLY
WITH A.D.A.
1-1/4"
(32mm)
6-3/4"
(171mm)
RIM OF
FOUNTAIN
32-1/2"
(826mm)
1-3/4"
(44mm)
DOTTED LINE
INDICATES OUTLINE
OF FOUNTAIN
1"
(25mm)
19"
(483mm)
1"
(25mm)
OPERATION OF QUICK CONNECT FITTINGS
SIMPLY PUSH IN
TUBE TO ATTACH
TUBE IS SECURED
IN POSITION
PUSH IN COLLET
TO RELEASE TUBE
PUSHING TUBE IN BEFORE
PULLING IT OUT HELPS TO
RELEASE TUBE
A B
C
NOTE: WATERFLOW
DIRECTION
SERVICE STOP
(NOT FURNISHED)
3/8" O.D. TUBE CONNECT
COLD WATER SUPPLY
BY OTHERS
1/4" O.D. TUBE
WATER INLET
TO COOLER
BUILDING WATER
INLET
INSTALLATION INSTRUCTIONS
1. Remove lower panel from drinking fountain by removing the two screws at
the lower corners. Rotate the bottom of the panel out and pull gently down-
ward to remove.
2. Water inlet tube to be 3/8" O.D. Waste tailpiece for slip trap is 1-1/4" O.D.
Contractor to supply waste trap in accordance with local codes.
3. Connecting lines to be copper and thoroughly flushed to remove all foreign
matter before connection to fountain assembly. The furnished strainer
should be installed in the supply line.
4. Connect the fountain to supply line with a shut off valve and install a 3/8"
(10mm) water line between the valve and fountain. Connect the 3/8 line to
the inlet of the strainer by loosening the retaining nut and inserting the tub-
ing past the o-rings (approximately 3/4"). Finger tighten nut to lock tubing
in place.
5. Stream height is factory set at 35 psi. If supply pressure varies greatly from
this, turn adjustment screw on regulator. Clockwise adjustment will raise
the stream and counter-clockwise adjustment will lower the stream. For
best adjustments, stream should hit the basin 6-1/2" (165mm) from the
bubbler.
ACTUATION OF QUICK CONNECT WATER FITTINGS
Fountain is provided with lead free connectors which utilize an o-ring water
seal. To remove tubing from the fitting, relieve water pressure, push in on gray
collar while pulling on the tubing. To insert tubing, push tube straight into the
fitting until it reaches a positive stop (approximately 3/4" [19mm]). See Fig. 1.
FIG. 1
FIG. 2
No Lead Drinking Fountain
Fully Recessed Wall Mount
Model EDFB12C
®
ROUGH-IN DIMENSIONS
Elkay
2222 Camden Court
Oak Brook, IL 60523
Printed in U.S.A.
©2003 Elkay
14-5F (Rev. 7/03)