Installation Sheet

Asana
™
Collection – Vessel Series
Installation Instructions
Asana
™
Collection – Vessel Series
®
Installation Instructions
STEP ONE
Position sink on countertop. Take into consideration
adequate clearance for the faucet, backsplash, and any
accessories.
STEP TWO
Cut countertop opening 3" in diameter following the
countertop manufacturer’s recommended instructions.
Installation Instructions
STEP THREE
Test cutout by placing the sink into the cutout.
STEP FOUR
Clean underside of sink and sealing surface of counter-
top opening thoroughly to remove dirt or residue.
Thoroughly dry and apply a continuous bead of high
quality silicone adhesive caulk (not furnished) to the
countertop, around opening.
STEP FIVE
Position sink in cutout, install drain (following drain manu-
facturer’s instructions) and flat washer (that is furnished
with sink), and tighten locknut to secure sink to counter-
top. Remove any excess caulk and allow to properly
cure following caulk manufacturer’s recommended
instructions.
STEP SIX
Install faucet, supply lines and drain fittings. Run water
and check for leaks.
CAREFULLY READ THESE INSTRUCTIONS BEFORE YOU BEGIN
• Follow all local standards and codes. Product does not have an overflow.
• Examine sink for damage prior to installation.
• Mounts to the countertop using the drain fitting.
COUNTERTOP
SURFACE
SEALANT
ADHESIVE CAULK
(NOT FURNISHED)
LOCKNUT
(NOT FURNISHED)
3" DIAMETER CUTOUT
TYPICAL DRAIN ASSEMBLY
(NOT FURNISHED)
FLAT
WASHER