Installation Sheet

DSSBF8S
[phone] Elkay Manufacturing Company
2000000216 (Rev. B - 08/21)
Page 9
5. Installation of Cooler
1. Remove the drain access panel by removing the
5/16" hex screws on the rear side of the cooler unit.
2. Position the cooler unit facing front side.
3. Remove the lower front panel by removing the two hex
screws on the cooler unit using a 5/16" socket or nut
driver.
4. Take the lter box and drain kit package out of the
cooler unit.
Note: Filter box and drain kit are packed inside the
cooler unit during shipment.
5. Attach the nut, the seal, and the elbow tube to the
drain outlet and tighten it fully.
6. Connect one end of P-trap to the water drain tube
and other end to the drain outlet.
Note: P-trap is installer supplied part.
Drain Access
Panel
Lower Front Panel
Drain Kit
Filter Box
Nut
Seal
Elbow
Tube
P-trap