Installation Sheet
14
Carbonaon Chiller, Fontemagna Bridge and Column Tap
Installaon and Maintenance Manual
6. Place the supply head on the counter top.
Fontemagna Bridge
1. Use the template provided in the kit to drill the
mounng holes on the counter top.
2. Insert the inlet tubes of the supply head through
the dedicated hole and secure the unit rmly to the
surface with the (4) screws M6 - 1mm x 40mm long
and (4) M6 washers provided.
Column Tap
1. Place the valves and fully ghten the ring nuts.
Screw in the knobs on the taps.
2. Drill a 1.375’’ to 1.5” diameter hole on the counter
top.
3. Insert the inlet tubes of the tap through the
holeand secure the unit rmly to the counter top
with the nut provided.
NOTICE: If the surface thickness is above 1.45 in (40 mm), buy appropriate replacement screws in a
specialized shop (Fontemagna Bridge only).
7. Connect the supply head to the undercounter water cooler.
1. Using the 3/8” tubing supplied, cut the tubing to the desired lenght and connect the incoming water tubes to
the Carbonaon Chiller water cooler. Pay aenon to the labels on the pipes.
2. Using the insulaon supplied, wrap the chilled and sparkling water tubes to minimize condensaon.
8. Plug the machine into the wall socket and turn it on.
1. Connect the power cable to the nearest socket (Carbonaon Chiller and Fontemagna Bridge only).
2. Flip the power switch at the front of the machine to the "I" posion (Carbonaon Chiller only).
NOTICE: Chilling of the ice bank begins immediately when unit is turned on. Complete chilling of ice
bank will require 1-3 hours. The machine should not be used as a water dispenser unl chilling is complete.