How to Guide

1. Remove (2) anges from cartridge holders and (1) ange nut from spout
holder or waterway.
TO INSTALL FAUCET
2. From underneath sink, insert waterway assembly up through sink faucet
drillings. From topside, thread ange onto center body. (See Figure 1.) Add
washer and sleeve. Insert spout assembly into sleeve and tighten spout nut.
Begin to unscrew ange until washer is attened against bottom of sleeve.
3. Topside, thread anges to faucet shanks and
align faucet.
4. From underneath, tighten (2) faucet locknuts.
5. Install handles (see Figure 2).
6. Connect faucet shanks to hot and cold water
supply tubes. Thread coupling nut onto faucet
shanks and tighten with wrench.
7. FLUSH WATER LINES to remove dirt and sed-
iment from water line. Turn on water supply.
Unscrew aerator from spout. Turn on HOT and
COLD water (together) for two minutes. Turn
o. Replace aerator.
How to Install Faucet Assembly
OPTION A
Plug Button
Handle Screw
Handle
Cartridge
OPTION C
Handle Screw
Handle
Cartridge
OPTION B
Plug Button
Handle Screw
Handle
Capnut
Cartridge
OPTION D
Handle
Screw
Handle
Cartridge
1. Insert handle over cartridge stem. Cartridge rotation should be clockwise for
hot and counterclockwise for cold, except for Option A. Option A both car-
tridges are clockwise.
2. Secure handle screw.
3. Insert plug button if applicable.
FIGURE 2
TYPICAL WATER SUPPLY HOOK-UPS
FLEXIBLE SINK RISERS WITH
BALL NOSE
Flexible sink risers available
in 3/8" or 1/2" O.D. sizes and
in various lengths wherever
plumbing supplies are sold.
SLIP JOINT CONNECTION
Use 3/8" O.D. copper tube
of proper length with cone
gasket and washer assembly
as shown. (Wherever plumbing
supplies are sold.)
1/4" TAILPIECE CONNECTION
Coupling nuts furnished
1/4" I.P.S. tailpiece available
wherever plumbing supplies
are sold.
1/2" I.P.S. Shank
3/8" O.D. or
1/2" O.D.
Flexible Supply
Coupling Nut
1/2" I.P.S. Shank
Important: Tube ends
must be ared.
Rubber Gasket
Washers
Coupling Nut
3/8" O.D.
Copper Tube
1/2" I.P.S. Shank
1/4" I.P.S. Tailpiece
Coupling Nut
SPOUT ASSEMBLY
SPOUT NUT
SLEEVE
WASHER
FLANGE
FLANGE
LOCKNUT
HOT BUTTON
HANDLE
SINK DECK
WASHER
WATERWAY
TOP OF
CENTER BODY
THREAD
FLANGE
DOWN TO
2-3/4"
FLANGE
SINK DECK
FIGURE 1
Elkay recommends installation by a licensed plumber.