Installation Guide

ManualsBrandsElkay ManualsKitchenWaterSentry Plus Replacement Filter EZH2O Water Filling Station (4-Pack)

PAGE 1 98523C (Rev. SIH - 06/19)

LIMITED WARRANTY

The ELKAY

WaterSentry

Plus is warranted to be free from defects in material and

workmanship for a period of one year from the date of installation. Warranty is limited

to repair or replacement of defective component.

Your Authorized Representative

Buyer

Seller

Elkay

WaterSentry

Plus

Lead, Chlorine, Taste & Odor, and Particulate Class I Reduction

Filter Part No. 51300C FOR EWF3000 - WaterSentry

Plus

FOR COMMERCIAL USE ONLY

PERFORMANCE DATA SHEET

IMPORTANT NOTICE: Read this Performance Data Sheet and compare the capabilities of

this unit with your actual water treatment needs. It is recommended that, before purchasing

a water treatment unit, you have your water supply tested to determine your actual water

treatment needs.

NOTICE: Do not use with water that is microbiologically unsafe or of unknown quality without

adequate disinfection before or after the system.

CAUTION: Use on cold water line only. Do not allow installed lter to freeze.

Capacity

Flow Rate

Temperature

3000 Gallons

1 Year Maximum

1.5 GPM

40-100° F (5-38° C)

RECOMMENDED USE CONDITIONS

Maximum Pressure 105 PSI (7.4 Kg/cm

)

Minimum Pressure 20 PSI (1.4 Kg/cm

)

NOTE: Performance will vary depending on local water conditions. While testing was performed

under standard laboratory conditions actual performance may vary.

NOTE: This system and installation shall comply with applicable state and local regulations.

NOTE: Filter must be used with lter monitor for 3000 gallon rating.

Instructions For Installing Replacement Filters

IMPORTANT NOTE

To avoid danger of an electric shock hazard, disconnect power

to your unit before installing or replacing the lter.

1. Turn off water supply; dispense water to relieve pressure

2. Turn used lter counterclockwise 1/4 turn to remove from lter head.

3. Remove cap from new lter and use to seal used lter.

4. Insert new lter into existing lter head and turn fully clockwise.

5. Turn on water supply and run a minimum of two gallons of water

through the lter to purge air and ne carbon particles from lter.

Also run water through glass ller (if provided).

The WaterSentry

Plus lter is tested and certied by NSF International to NSF/ANSI 42 and 53

for the reduction of Chlorine, Taste and Odor, Particulate Class I, and Lead.

Summary of content (2 pages)

PAGE 1
Elkay WaterSentry® Plus ® Lead, Chlorine, Taste & Odor, and Particulate Class I Reduction Filter Part No. 51300C FOR EWF3000 - WaterSentry® Plus FOR COMMERCIAL USE ONLY PERFORMANCE DATA SHEET ® The WaterSentry Plus filter is tested and certified by NSF International to NSF/ANSI 42 and 53 for the reduction of Chlorine, Taste and Odor, Particulate Class I, and Lead. IMPORTANT NOTICE: Read this Performance Data Sheet and compare the capabilities of this unit with your actual water treatment needs.
PAGE 2
Performance Test Conditions NSF/ANSI 42 NSF/ANSI 53 Chlorine Reduction Particulate Class I Reduction Taste and Odor Reduction Lead Reduction Capacity 3000 Gallons (11356 l) Flow Rate 1.5 gpm (2.8 l/m) Pressure 60 psi (4.2 kg/cm2) Temperature 68-70o F (20-21o C) This system has been tested according to NSF/ANSI 42 and 53 for reduction of the substances listed below.