Installation

Page 41000005920 (Rev. A - 09/20)
1000005921
17. Squeeze the strain relief and place in the slot in the bracket that the old
power cord was removed. Push up until it locks into place. See Fig.7.
18. Put the ground screw in the ring terminal on the green ground wire on the
power cord. Tighten the screw back into the frame where the old ground
wire was connected. Tighten the screw so that the terminal will not turn.
To make sure that the grounding connection is secure, use a multi-meter
and check for continuity. Place one probe on the round connector on the
plug and the other probe on the frame. See Fig.8.
19. Connect both female connections on the power cord to both open
terminals on the cold control. It does not matter which connector goes
on which terminal. If the connections do not reach, spread the wire apart
more to gain length. See Fig.9.
Fig. 7
Fig. 8
Fig. 9