Installation
Page 3 1000005920 (Rev. A - 09/20)
1000005921
13. Remove the power cord ground connection on the frame using the ΒΌ nut
driver. Keep this screw it will be needed to connect the ground wire on the
new power cord. See Fig.4.
12. Place the new shroud on the basin and attach it using the screws removed. Note: If a regulator was removed from the old shroud it will need
to be inserted in the new shroud before installing on the basin.
14. Using pliers, squeeze the strain relief on the power cord and pull up to
remove the cord from the bracket. See Fig.5.
15. Remove the remaining wire from the solenoid and discard the old power cord.
16. Measure 23 inches from the plug end of the power cord and place the strain
relief on the cord at that point. See Fig.6.
Fig. 4
Fig. 5
Fig. 6