Installation manual
M1G Installation and Programming
Page 46
UR001: Selb Prgr
[Name of User]
UR001:O=00 C=00r
[Name of User]
Menu 13 - User Report Codes
13-User Report
Codes r
User Report Codes Description of Option
Each of the 99 User Codes and the Installer has communicator reporting codes for Open
(disarm) and Close (arm). Using the up/down arrow keys, select the appropriate user,
then press the right arrow key to begin programming of that user’s report codes.
The cursor starts at the 00 beside O (Open). Enter the desired two digit reporting code
and press the right arrow key to advance to the C (Close). Range is 00 to FF. Default is
00 (no report). To jump the cursor to the next report code without changing this one
simply press the right arrow key. The next press of the right arrow key will advance back
to the beginning screen.
Press RIGHT arrow key to select this menu. Press UP or DOWN arrow keys to select
another menu. The ELK key backs up one menu level. To exit press the * or Exit key.
NOTE: Enter a two digit value to enable a report code. To disable a report code enter 00. When SIA or Contact ID is the
reporting format, the two digit value can simply be 01 since the control automatically produces the correct code
according to the SIA or Contact ID protocol. For 4+2 pulse format, enter a value from 01 to FF. To enter the A thru F
HEX characters press the RIGHT arrow key to position the cursor under the desired digit, then press the UP arrow (shift)
key once. Each press of the 2 key will now produce the following: 2, A, B, C. Each press of the 3 key will now produce
the following: 3, D, E, F. Press the RIGHT arrow key to cancel shift and move to the next character. See Appendix for
a summary of the SIA and Contact ID codes.
User RCs CID SIA
Open 401 OP
Close 401 CL
The CID (Contact ID) or SIA Codes for User Reporting Codes are:
NOTE: On CID reporting the 3 digit code is preceded by a “1” for an opening
event or a “3” for a closing event.
The total number of available User Codes is dependent on the
Version of Firmware that is operating in the control.
UR201:O=00 C=00r
Installer Op/Close
UR202:O=00 C=00r
Up/Dnload Op/Cl
UR203:O=00 C=00r
Quick Arm