Installation manual

M1G Installation and Programming
Page 20
Menu 0 - Select Keypad Alternate Area - Multi-area (Partition) Operation
Press the RIGHT arrow key to select this menu and display the following:
Enter a valid user code. The control does not allow (restricts) mapping or viewing of
areas that are not authorized for the user code.
MAPPING TO AN INDIVIDUAL AREA
Enter an area number from 1 to 8 OR scroll UP and DOWN with the arrow keys.
Press the Right Arrow key to map the Keypad to the area shown. The LCD display
and the Ready / Armed LEDs will show the status for the mapped area for 1 minute.
During this minute, it is possible to arm, disarm, bypass, etc. the mapped area from
this keypad. Each time a key is pressed the 1 minute is restarted. However, after 1
minute of no keypress activity, the keypad will return to its original primary assigned
area.
ACCESSING A CONSOLIDATED DISPLAY OF ALL VALID AREAS
Entering “0” for the area number immediately maps the Keypad to a consolidated
‘snapshot’ of all authorized areas. This permits quick arming and disarming only. If an
area is not ready to arm it will be necessary to map individually to that area to view the
violated zone(s) and either secure or bypass them prior to arming.
This example shows all 8 areas, meaning that the User Code was valid for all 8.
The display only shows the areas for which the user code is authorized.
This menu allows the keypad to be mapped temporarily to any other area, allowing multi-area (partitioned) operation.
An individually mapped area can be armed, disarmed, and controlled just as if the keypad were permanently assigned
to that area. It may also be used to access a consolidated display of all areas at once, showing the status of each
area.
To reach the keypad menus press the center navigation key labeled “ELK”. A user code may be required depending on
how the control is programmed. The four arrow keys around the Elk key are used to scroll, backup, etc. Pressing the
RIGHT arrow key will select the displayed menu.
1. Press the ELK key. Enter a user code if prompted.
2. Use the UP or DOWN arrow keys to find menu “0-Select Keypad Alternate Area”.
0-Select Keypad
Alternate Area r
Auth. Required
Enter Valid PIN
ChangeKPArea-1 r
[Area Name] A1
Note the letter beneath each area number.
The single upper case “X” indicates the primary area. This area is controlled exclusively from
the regular operation screens.
A lower case “r” below an area indicates the area is Ready to Arm.
A lower case “n” below an area indicates the area is Not Ready.
A upper case “A” below an area indicates the area is Armed.
This example shows the user code was only authorized for areas 1, 2, and 3. The
unauthorized area(s) have a “-” below them.
To change or ‘toggle’ the arm status of an area, press the number key representing
the area number. IMPORTANT: The area status is not “real time”. It is a snapshot
taken when the RIGHT arrow key was pressed. If a zone has since become violated
the area will still be displaying “r”, however the letter will immediately change to “n”
and the keypad will emit an error tone when an attempt is made to arm by pressing
the area number.
When finished, press the “*” key to exit.
ChangeKPArea-0 r
0=All Areas
Area# 12345678
Status X r r r r r r r
Area# 12345678
Status X r r - - - - - r