Instruction Manual

-2-
elkhome.com
F
5. Attach one locking link (G) to loop on top of
xture body (O).
6. Determine desired hanging height of xture.
Cut chain (H) to length to achieve desired
height.
7. Slip chain link at end of chain (H) onto locking
link (G) on loop.
8. Weave xture wires through chain links,
skipping every other chain link.
9. Slip threaded ring (F) down over end of chain (H)
with xture wires.
10. Position canopy (D) so outside of canopy is
pointing down towards xture. Slip hole in
canopy (D) over end of chain (H).
D
O
G
W
JUNCTION BOX
GROUND
SCREW
HOUSE
GROUND
WIRE
(COPPER)
FIXTURE
GROUND
WIRE
C
A
Connect Supply (House) Ground Copper Wire to:
Bare Copper Wire or,
Bare Silver Wire or,
Green Insulated Wire.
H
G
11. Strip 3/4” of insulation from ends of xture
wires.
12. Carefully push xture wires up through hole
in screw collar loop (W) attached to mounting
bracket (A) and out end of threaded pipe inside
junction box. Carefully pull xture wires so they
are easily accessible to connect to house wires.
13. To aid in connecting xture wires to house
wires, temporarily connect second locking link
(G) to link at end of chain (H) and to screw collar
loop (W).
14. Slightly loosen ground screw on mounting
bracket (A). Do not completely remove ground
screw. Wrap house ground wire (copper) around
ground screw, leaving enough ground wire
to attach to xture ground wire. Twist end of
xture ground wire and end of house ground
wire together. Twist wire nut (C) onto ends of
wires. Completely tighten wire nut (C). Reference
chart below for correct wire connections.
LOOP
ITEM#: 82255/3
ITEM#: 82265/3
ITEM#: 82275/3