Instruction Manual

-1-
elkhome.com
1. Hold mounting bracket (A) so tabs on mounting
bracket (A) are on the left and right and facing
out.
2. Carefully pull house wires through round hole in
mounting bracket (A).
3. Align holes in mounting bracket (A) with holes
in junction box. Ensure mounting bracket (A) is
level.
4. Thread each junction box screw (B) into holes in
mounting bracket (A) and into holes in junction
box. Tighten junction box screws (B) to secure
mounting bracket (A) to junction box. CAUTION:
Make sure house wires are pulled completely
through hole in mounting bracket. DO NOT
pinch wires between mounting bracket and wall.
A
JUNCTION
BOX
ITEM#: 82180/1
WARNING: DISCONNECT POWER AT THE MAIN
FUSE BOX BEFORE INSTALLATION.
WARNING:
This xture is intended for installation in
accordance with the National Electrical Code
(NEC) and all local code specications. If you are
not familiar with code requirements, installation
by a certied electrician is recommended.
Before assembly, remove all parts and part
packages from box. If anything is missing, please
contact the retailer from which the product was
purchased.
5. Strip 3/4” of insulation from ends of xture
wires.
6. Slightly loosen ground screw on mounting
bracket (A). Do not completely remove ground
screw. Wrap house ground wire (copper) around
ground screw, leaving enough ground wire
to attach to xture ground wire. Twist end of
xture ground wire and end of house ground
wire together. Twist wire nut (C) onto ends of
wires. Completely tighten wire nut (C). Reference
chart below for correct wire connections.
GROUND
SCREW
A
HOUSE GROUND
WIRE (COPPER)
FIXTURE
GROUND
WIRE
C
ANY QUESTIONS CALL: 800-613-3261
M-F 8:00AM-6:00PM ET
Connect Supply (House) Ground Copper Wire to:
Bare Copper Wire or,
Bare Silver Wire or,
Green Insulated Wire.
B
TAB
TAB
B
Français p. 3
Español p. 5