Installation Instructions

BY AMERICAN STANDARD
© 2021 Eljer
5/21
TILE BEAD KIT
INSTALLATION INSTRUCTIONS
NOTE: Apply the Tile Bead before installing
the whirlpool.
Step #1 – Clean the whirlpool rim thoroughly.
Step #2 – Measure amount of Tile Bead to be
used based on the length and width of
whirlpool rim. Start and finish the Tile Bead
3/4" (19mm) in from the ends of the whirlpool.
Step #3 – Identify the corner locations and
notch the Tile Bead so the bead can bend
around the corner. Do not notch through the
tile bead.
Step #4 – Apply adhesive to whirlpool rim at
location shown.
Step #5 – Mount the tile bead to the
adhesive/whirlpool rim starting at one corner,
making sure the back of the Tile Bead is
vertical. Press and knead the Tile Bead in
place to provide a watertight seal.
Whirlpool is now ready for installation.
Please follow the installation instructions
enclosed in the whirlpool bathtub.
Suggested Installation Method
TILE BEAD
ADHESIVE
CLEAN THIS AREA
NOTCH CORNERS
3/4"
(19 mm)
TILE BEAD
WITH ADHESIVE
BACK OF TILE BEAD
SHOULD BE VERTICAL
TILE
TILE
BEAD
STRI P
LEVELING
STRI NGER
BATH
ADHESIV E
SEALANT
WALLBOARD
752766-101

Summary of content (2 pages)