Installation Guide

1.Remove the washer and brass nut from the riser joint the faucet body. See below illustration.

2.Be sure there is a washer in the under the brass nut of cradle, then connect the cradle to the

faucet body. Tighten the brass nut.

3.Attach the hose to the outlet of the cradle and the hand shower. Place the hand shower on the

cradle.

NOTE: USE TEFLON TAPE ON ALL THREADED CONNECTIONS

Assembly Instructions for HSWC10

NOTE: Remove the washer and brass nut from the riser joint on the faucet

body before installation.

Hose

Hand Shower

Brass Nut

Washer

Outlet

Brass Nut

Washer

Cradle

Elizabethan

Classics

NOTE: TO BE INSTALLED ONLY BY QUALIFIED, LICENSED PLUMBER

CAUTION: DO NOT OVER TIGHTEN NUTS - THIS CAN LEAD TO STRIPPING OR

CRACKING AND WILL VOID YOUR WARRANTY.

Rev.D