Installation Guide

FAUCET INSTALLATION:

1.Shut off the water supply valves before installation.

2.According to your requirement, connect the riser or swivel arm connector kit to the faucet

body.

3.Remove cap from the diverter lever, attach the diverter lever onto diverter valve and tighten

the diverter screw,put the cap back.

4.After installation in completed, turn on the water supply valves and allow both hot and cold

water to run at least one minute each. While water is running, check for leaks, especially at

hook-ups to supply lines. Tightening nuts slightly will stop any minor leaks.

NOTE: USE TEFLON TAPE ON ALL THREADED CONNECTIONS

Cross Handles:

1.Put the cross handles on the broaches and then tighten the screws.

2.Insert the caps on the cross handles.

Faucet body

Diverter lever

Diverter screw

Cap

Caps

Screw

Cross Handle

Broach

Elizabethan

Classics

NOTE: TO BE INSTALLED ONLY BY QUALIFIED, LICENSED PLUMBER

Rev.D

CAUTION: DO NOT OVER TIGHTEN NUTS AND SCREWS - THIS CAN LEAD TO

STRIPPING OR CRACKING AND WILL VOID YOUR WARRANTY.

RM10

Assembly Instructions for 3V10

PAGE 1
R Elizabethan Classics RM10 Assembly Instructions for 3V10 CAUTION: DO NOT OVER TIGHTEN NUTS AND SCREWS - THIS CAN LEAD TO STRIPPING OR CRACKING AND WILL VOID YOUR WARRANTY. NOTE: TO BE INSTALLED ONLY BY QUALIFIED, LICENSED PLUMBER NOTE: USE TEFLON TAPE ON ALL THREADED CONNECTIONS FAUCET INSTALLATION: 1.Shut off the water supply valves before installation. 2.According to your requirement, connect the riser or swivel arm connector kit to the faucet body. 3.
PAGE 2
R Elizabethan Classics Coupling Nut 90 degree elbow Rubber Washer Assembly Instructions for 6RMN Faucet Supply Shank CAUTION: DO NOT OVER TIGHTEN NUTS - THIS CAN LEAD TO STRIPPING OR CRACKING AND WILL VOID YOUR WARRANTY. NOTE: TO BE INSTALLED ONLY BY QUALIFIED, LICENSED PLUMBER NOTE: USE TEFLON TAPE ON ALL THREADED CONNECTIONS NOTE : REQUIRE ECSSL STRAIGHT BATH SUPPLY LINES WHICH INCLUDE SUPPLY LINE NUTS, FRICTION RINGS, AND CONE WASHERS. 1. Shut off the main water supply valves before installation.
PAGE 3
R Elizabethan Classics Assembly Instructions for HSWC10 CAUTION: DO NOT OVER TIGHTEN NUTS - THIS CAN LEAD TO STRIPPING OR CRACKING AND WILL VOID YOUR WARRANTY. NOTE: TO BE INSTALLED ONLY BY QUALIFIED, LICENSED PLUMBER NOTE: USE TEFLON TAPE ON ALL THREADED CONNECTIONS 1.Remove the washer and brass nut from the riser joint the faucet body. See below illustration. 2.Be sure there is a washer in the under the brass nut of cradle, then connect the cradle to the faucet body. Tighten the brass nut. 3.