Installation Guide

1.Place the round rubber washer in the riser joint and attach the adapter & shower arm to the

rise joint.

2.Place the cone washer around the end of the shower riser that you will fit into the adapter & shower

arm diverter. Slide the brass nut onto the other end of the shower riser and slide it down so that it sits

on top of the cone washer. Place this end of the shower riser into the top of the adapter & shower arm

diverter and tighten the brass nut.

3.Slide the cradle onto the shower riser and secure it in the desired location by tightening the

allen screw.

4.Attach the hose to the shower arm diverter and the hand shower. Place the hand shower on the cradle.

NOTE: USE TEFLON TAPE ON ALL THREADED CONNECTIONS

Assembly Instructions for HSCKIT10

Hose

Cone Washer

Allen Screw

Brass Nut

Shower Riser

Adapter & Shower Arm Diverter

Washer

Riser Joint

Washer

Cradle

Hand Shower

Elizabethan

Classics

NOTE: TO BE INSTALLED ONLY BY QUALIFIED, LICENSED PLUMBER

Rev.D

CAUTION: DO NOT OVER TIGHTEN NUTS - THIS CAN LEAD TO STRIPPING OR

CRACKING AND WILL VOID YOUR WARRANTY.

AND SCREWS

PAGE 1
R Elizabethan Classics Assembly Instructions for HSCKIT10 CAUTION: DO NOT OVER TIGHTEN NUTS AND SCREWS- THIS CAN LEAD TO STRIPPING OR CRACKING AND WILL VOID YOUR WARRANTY. NOTE: TO BE INSTALLED ONLY BY QUALIFIED, LICENSED PLUMBER NOTE: USE TEFLON TAPE ON ALL THREADED CONNECTIONS 1.Place the round rubber washer in the riser joint and attach the adapter & shower arm to the rise joint. 2.Place the cone washer around the end of the shower riser that you will fit into the adapter & shower arm diverter.