Installation Guide

ManualsBrandsElizabethan Classics ManualsBathWall-Mount Exposed Shower Faucet in Oil Rubbed Bronze

Assembly Instructions for ES01-03

NOTE: USE TEFLON TAPE ON ALL THREADED CONNECTIONS

1.Shut off the main water supply valves before installation.

2.Thread the Brass Nipple into wall stub, the nipple should extend 3/8 to 1/2"

from the front of the finished wall.

3.Remove the Eccentric Shanks from faucet and keep escutcheons on shanks.

4.Thread Eccentric Shanks onto each cold and hot Brass Nipple. Ensure each

escutcheon is snug against the finished wall.

8.Thread the Riser Connector onto faucet.

9.Thread the Riser onto 90 degree elbow. Slide the Brace Connector onto Riser.

10.Slide the Riser Nut onto Riser and install the Cone Washer at end of Riser.

Insert the Riser into the Riser Connector. Align showerhead toward the front.

Tighten the Riser Nut onto Riser Connector

11.Measure the distance from Brace Connector to the wall. Cut the unthreaded

end of Brace. Move the Brace Connector to the location which is approximate

11-1/2 below the 90 degree elbow to hide the connecting seam on Riser. Fix the

Brace Connector by Set Screw.Insert the unthreaded end into Brace Connector

and install the Brace to finished wall by Anchor Bolts.

Align and level Eccentric Shanks with a 10mm Allen wrench. Ensure the center

distance of Coupling Nuts is 3-1/2".

Insert one Rubber Washer into each cold and hot Coupling Nut.

Insert the faucet into each cold and hot Coupling Nut. Partially thread the

Coupling Nuts onto faucet until tight.

Elizabethan

Classics

Assembly Instructions for Handles

Lever Handles:

1. Be sure that the broach screws are tightened installing the lever handles.

2. Install the lever handles on the broaches and tighten the set screws using the allen

wrench provided.

before

Cross Handles:

1. Remove the screws from the top of the broaches.

2. Remove the insert caps from the cross handles.

3. Put the cross handles on the broaches and then tighten the screws. Insert the caps on

the cross handles.

Broach

Screw

Set

Screw

Allen

Wrench

Rev.B

90 degree elbow

Riser

Anchor Bolt

Brace

Set Screw

Brace Connector

Finished Wall

Riser Connector

Riser Nut

Cone Washer

Faucet

Coupling Nut

Brass Nipple

Escutcheon

Eccentric Shank

Rubber Washer

CAUTION: DO NOT OVER TIGHTEN NUTS - THIS CAN LEAD

TO STRIPPING OR CRACKING AND WILL VOID YOUR

WARRANTY.

AND SCREWS

NOTE: TO BE INSTALLED ONLY BY QUALIFIED, LICENSED PLUMBER