Datasheet

M2Y(F)1G64TU88G7(4) B / M2Y(F)2G64TU8HG5(4) B
1GB: 128M x 64 / 2GB: 256M x 64
Unbuffered DDR2 SDRAM DIMM
REV 1.0 9
10/2010
© NANYA TECHNOLOGY CORP.
NANYA TECHNOLOGY CORP. reserves the right to change Products and Specifications without notice.
Absolute Maximum Ratings
Symbol
Parameter
Rating
Units
V
IN
, V
OUT
Voltage on any pin relative to Vss
-0.5 to 2.3
V
V
DDQ
Voltage on V
DDQ
supply relative to Vss
-0.5 to 2.3
V
V
DDQL
Voltage on V
DDQL
supply relative to Vss
-0.5 to 2.3
V
V
DD
Voltage on VDD supply relative to Vss
-1.0 to +2.3
V
Note: Stresses greater than those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. This is stress
rating only, and functional operation of the device at these or any other conditions above those indicated in the operational sections of
this specification is not implied. Exposure to absolute maximum rating conditions for extended periods may affect reliability.
DC Operating Conditions
Symbol
Parameter
Rating
Units
Note
T
CASE
Operating Temperature (Ambient)
0 to 95
°C
1,2,3
T
STG
Storage Temperature (Plastic)
-55 to 100
°C
I
L
Short Circuit Output Current
-5 to 5
Μa
Note:
1. Case temperature is measured at top and center side of any DRAMs.
2. t
CASE
> 85°C t
REFI
= 3.9 μs
3. All DRAM specification only support 0°C < t
CASE
< 85°C
DC Electrical Characteristics and Operating Conditions
(T
CASE
= 0 °C ~ 85 °C; V
DDQ
= 1.8V ± 0.1V; V
DD
= 1.8V ± 0.1V, See AC Characteristics)
Symbol
Parameter
Min
Max
Units
Notes
VDD
Supply Voltage
1.7
1.9
V
1
VDDQ
Supply Voltage for Output
1.7
1.9
V
1, 3
VDDL
Supply Voltage for VDDQL
1.7
1.9
V
3
VREF
Input Reference Voltage
0.49VDDQ
0.51VDDQ
Mv
2
VTT
Termination Voltage
VREF 0.04
VREF + 0.04
V
4
VIH (DC)
Input High (Logic1) Voltage
VREF + 0.125
VDDQ + 0.3
V
VIL (DC)
Input Low (Logic0) Voltage
-0.3
VREF 0.125
V
Note:
1. Inputs are not recognized as valid until VREF stabilizes.
2. VREF is expected to be equal to 0.5 V DDQ of the transmitting device, and to track variations in the DC level of the same.
Peak-to-peak noise on VREF may not exceed 2% of the DC value.
3. VDDQ tracks with VDD, VDDL tracks with VDD.
4. VTT of transmitting device track VREF of receiving device.
Environmental Parameters
Symbol
Parameter
Rating
Units
Note
T
OPR
Module Operating Temperature Range (ambient)
0 to 55
°C
3
H
OPR
Operating Humidity (relative)
10 to 90
%
T
STG
Storage Temperature (Plastic)
-55 to 100
°C
1
H
STG
Storage Humidity (without condensation)
5 to 95
%
1
P
BAR
Barometric Pressure (operating & storage)
105 to 69
K Pascal
1,2
Note:
1. Stresses greater than those listed may cause permanent damage to the device. This is a tress rating only and device functional
operation at or above the conditions indicated is not implied. Exposure to absolute maximum rating conditions for extended periods
may affect reliability.
2. Up to 9850 ft.
3. The component maximum case temperature shall not exceed the value specified in the component spec.