User Manual

Step 3 Install front support and extensions
Step 2B Wall plate installation (concrete or brick)
2A-3
7/32 in
Ø5.5 mm
2.75in (70 mm)
Drill pilot holes using a 7/32 in.
(5.5 mm) diameter drill bit.
IMPORTANT:
Pilot holes must be drilled to a depth
of 2 3/4 in (70 mm). Be sure to drill into the center of the stud.
Drill pilot
holes
Concrete Wall
Concrete Wall
2.75in (70 mm）
Ø 10 mm
Ø 10 mm
3/8in
01
A
B
01
Install wall plate using lag bolts , washer and anchor (not included).
Tighten the lag bolts until they are pulled firmly against the wall plate .
A
2B-2
01
2B-3
Contact us to have these
additional pieces shipped directly
to you.
Concrete wall anchor 4pcs (NOT INCLUDED)
Adjustments
Product dimensions:
Position the mounting template
at your desired height , level the
mounting template and mark the
pilot hole locations x4.
A
B
2A-4
01
UP
To prevent the TV falling down, the Arrow
Must Keep UP at this step!!
No!
01
A B
01
Install wall plate using lag bolts and washers with Socket Wrench, NO
Electrodrill. Tighten the lag bolts until they are pulled firmly against the wall plate .
A
No!
2
How to install your TV with an optimal viewing height?
Experts agree that 42 inches from the center of the TV to
the floor is ideal.
3-Step installation ( DO NOT MOUNT ON DRYWALL ALONE!)
1 Install wall plate. 2 Attach bracket to TV back.
3 Hang TV onto wall plate.
Attention on the VESA (TV Mounting Holes) location.
2
Mounting template
Bubble Level
A
B
3-1 4-1 4-2 4-3
2. Remove the pre-assembled screws x4
3. Insert the arm extension
Install the extensions [03] to Front support [02] with the pre-assembled screws.
1. Loosen a little
[02]
[03]
4. Fasten the all 8 screws.
3-2
P1
P2
Hang 02 onto 01 and using a screwdriver to secure with pre-assembled screws
and washer .
P1
P2
02
03
03
02
Step 4 Hang TV with bracketsonto the arm extensions
P3
P3
Remove the
pre-assembled
screws [P3] and
save to use, then
raise the safety
locks.
Press the safety locks
then fasten the removed
screws [P3].
04
02
03
P3
P3
Adjustments
TV leveling adjustment (-3°/+3°)
Loosen
±3°
Loosen 2 leveling bolts on the rear of TV plate with the
open- end wrench , adjust to level, and retighten to
secure.
C
Tool-free Tilting Adjustment
-10°
+5°
If necessary
C
Tighten
Loosen
If TV keeps tilting down, pull TV to desired
angle then fasten tilting nuts with open-end
wrench.
~


~

/+°
~
+/°
"
02 01
UP
To prevent the TV falling down, the
Arrow Must Keep UP at this step!!
Tighten
Ø10*61mm
76
8
11
10
9