Owner manual
19
Using BIOS
CPU Configuration
The item in the menu shows the information of the CPU.
Inter(R) Celeron (R) CPU G550 @ 2.60GHz
This is display-only field and diaplays the information of the CPU installed in your
computer
.
EMT64 (Supported)
This item shows the computer supports EMT64.
Processor Speed (2600MHz)
This item shows the processor speed.
Processor Stepping (206a7)
This item shows the information of processor stepping.
Microcode Revision (25)
This item shows the Microcode revision.
Processor Cores (2)
This item shows the information of the processor cores.
Intel HT Technology (Supported)
This item shows your computer does not support Intel HT technology or not.
Active Processor Cores (All)
Use this item to control the active processor cores.
Intel VT-x Technology (Supported)
This item shows your computer does not support Intel VT-x technology or not.
Limit CPUID Maximum
(Disabled)
Use this item to enable or disable the maximum CPUID value limit. You can enable
this item to prevent the system from “rebooting” when trying to install Windows
NT 4.0.
Main Advanced Chipset Freq/Volt Control Boot Security Exit
+/- : Change Opt.
Enter/Dbl Click : Select
: Select Screen
/Click: Select Item
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC/Right Click: Exit
Number of cores to enable
in each processor package.
CPU Configuration
Intel(R) Celeron(R) CPU G550 @ 2.60GHz
EMT64 Supported
Processor Speed 2600 MHz
Processor Stepping 206a7
Microcode Revision 25
Processor Cores 2
Intel HT Technology Not Supported
Intel VT-x Technology Supported
Active Processor Cores All
Limit CPUID Maximum Disabled
Execute Disable Bit Enabled
Intel Virtualization Technology Enabled
CPU C3 Report Disabled
CPU C6 Report Enabled
Enhanced Halt (C1E) Enabled