User's Manual
Notice and Safety
Any changes or modiļ¬cations not expressly approved by the grantee of this device could void the user's authority to
operate the equipment.
Declaration the Restriction of this Limited Module Approval:
According to FCC Part 15 Subpart C Section 15.212, the radio elements of the modular transmitter must have their own
shielding. However, due to there is no shielding for this Module, this module is granted as a Limited Modular Approval.
When this Module is installed into the end product, a Class II Permissive Change or a New FCC ID submission is required
to ensure the full compliance of FCC relevant requirements.
10cm minimum distance has to be able to be maintained between the antenna and the users for the host this module is
integrated into. Under such configuration, the FCC radiation exposure limits set forth for an opulation/uncontrolled
environment can be satisfied.
Only FCC approved antenna can be used for the module integrated into host.
LABEL OF THE END PRODUCT:
The final end product must be labeled in a visible area with the following" Contains TX FCC ID: WL6WCPTI-S".
FCC Label Compliance Statement:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference
(2) This device must accept any interference received, including interference that may cause undesired operation.