FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
CAUTION: Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
End Product Labeling This transmitter module is authorized only for use in device where the antenna may be installed such that 20cm may be maintained between the antenna and users. The final end product must be labeled in a visible area with the following: "Contains FCC ID: WL6-TRBC41CD1” Information for the OEMs and Integrators The following statement must be included with all versions of this document supplied to an OEM or integrator, but should not be distributed to the end user.
Antenna List No. Manufacturer Part No. Antenna Type 1 PIFA Antenna(Main) WGT 13H130-JV1050 Peak Gain 1.65 dBi For 2.4GHz 2.36 dBi For 5.15~5.35GHz 1.78 dBi For 5.47~5.725GHz 1.78 dBi For 5.725~5.850GHz Pulse 02H475-006500 Chip Antenna (Aux) 3.2 dBi For 2.4GHz 4.2 dBi For 5.15~5.35GHz 4.2 dBi For 5.47~5.725GHz 4.2 dBi For 5.725~5.850GHz 2 JEM 13H130-JV1070 PIFA Antenna (Main) 1.77 dBi For 2.4GHz 1.55 dBi For 5.15~5.35GHz -0.56 dBi For 5.47~5.725GHz -0.14 dBi For 5.725~5.
Motherboard Layout Main components No. Name No.
System connectors No. Name No.
I/O Ports No. Name No.
