User's Manual

1. Do not replace battery yourself. Please contact a qualified technician or your retail
provider.
Caution! 2 .The computer is provided with a battery-powered real-time clock circuit. There is a
danger recommended by the manufacturer. Discard used batteries according to the
manufacturer's instructions.
1. Ne pas remplacer la batterie vous-même. S'il vous plaît contacter un technicien qualifié
Attention! ouvotre fournisseur de détail.
2. L'ordinateur est muni d'un circuit en temps réel de l'horloge alimentée par batterie. Il ya
un danger d'explosion si la pile est remplacée de façon incorrecte. Remplacez
uniquement par un type identique ou équivalent recommandé par le fabricant. Jetez les
piles usagées selon les instructions du fabricant.
17. CLASSIFICATION: Supply Class II adapter
(EDAC, EM1024PR)
No applied part
Continuous Operation
Not AP or APG category
18.Disconnect device: Removed the supply plug of direct plug–in adapter from the wall.
19.Follow national, state or local requirements to dispose of unit.
20.Maintenance: to properly maintain and clean the surfaces, use only the approved products or clean with a
dry applicator.
21.Contact information:
No.239, Sec. 2, Tiding Blvd., Neihu District, Taipei City 11493, Taiwan (R.O.C.).
TEL: [phone]
22.This equipment shall not be used as a life support system.
23. Accessory equipment connected to the analog and digital interfaces must be in compliance with the
respective nationally harmonized IEC standards (i.e. IEC
60950 for data processing equipment, IEC 60065 for video equipment, IEC
61010-1 for laboratory equipment, and IEC 60601-1 for medical equipment.) Furthermore all configurations
shall comply with the system standard IEC
60601-1-1. Anyone who connects additional equipment to the signal input part or signal output part is
configuring a medical system, and is therefore, responsible that the system complies with the requirements of
the system standard IEC
60601-1-1. The unit is for exclusive interconnection with IEC 60601-1 certified equipment in the patient
environment and IEC 60XXX certified equipment out- side of the patient environment. If in doubt, consult the
technical services department or your local representative.
24.Users must not allow SIP/SOPs to come into contact with the patient at the same time.
25.The sound pressure level at the operator's position according to IEC 704-1:1982
is no more than 70dB (A).
DISCLAIMER: This set of instructions is given according to IEC 704-1. ECS disclaims all responsibility for the
accuracy of any statements contained herein.
26. Turning off 7” multi function Pad, mPAD2-7-CHT4-M properly is important for system reliability.
There are two ways to turn off the system.
1. On the start menu, click “Shut down” and select “OK”
2. Push the power button and then the system will shut down automatically
mPAD2-7-CHT4-I Tablet PC User Manual vii