TA80CA1 Quick Start Guide
TA80CA1 Quick Start Guide Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. FOR PORTABLE DEVICE USAGE Radiation Exposure Statement: The product comply with the FCC portable RF exposure limit set forth for an uncontrolled environment and are safe for intended operation as described in this manual.
Tablet layout 4 5 2 1 6 3 7 8 9 No. Name No.
2 1 3 5 4 No. Name No.
Charging your tablet If your tablet is just being unpacked from the box, you need to charge the tablet first. It will take around 4 to 5 hours to be fully charged. 2 1 3 1. Plug the USB head of the cable into the adapter. 2. Plug the micro-USB head of the cable into the micro-USB port on your tablet. 3. Plug the adapter into a wall-socket. 4. If the battery starts charging, you will see: When power off When power on A large icon appears for a few seconds.
Inserting your mobile network card (optional) For the optional mobile network card, follow the steps below to install it. 1. Turn off your tablet. 2. Flip open and remove the cover of the card slot. 3. Insert your mobile network card. 4. Close the cover. Note：Whether or not a mobile network card is installed, keep the cover closed at all times.
Powering ON/OFF your tablet To power on your tablet Press and hold the power button down until the screen turn on. To power off your tablet 1. Press and hold the power button until the power options menu appears on the screen. 2. Tap and choose OK from the menu.
Inserting a storage card Your tablet supports micro-SD cards with storage space ranging from 128M to 32G. You can insert the micro SD card and pull it out without powering down the tablet. To do so, follow the steps below. Install your Micro SD Card 1. Hold your tablet with front side up. 2. Insert your micro SD card in the direction as shown. Remove your Micro SD Card 1. Push and release the micro SD card. This will unlock the card. 2. Pull out the micro SD card.
Specifications Processor l Intel Clovertrail+ Z2560 Memory l 1 GB or 2 GB (optional) LPDDR2 Storage l 16GB Wireless l l l l l l l l l l l WLAN, Bluetooth Mobile Network 8-inch 800x1280 screen Support10-pointsmulti-touch Front camera: 2.0 M Rear camera: 5.0 M 1Cell,1S1P Li-polymer 4150 mAh TCL:TA80-1S4150-T1T2 1 x micro-USB 2.0, OTG port (Type A/B) 1 x Mic/head phone jack combo 1 x mini-HDMI 1.
l Mobile Network (optional) l l l l l HSUPA/HSDPA/WCDMA: 2100(900/850) GSM: 1800, 900 HSDPA: 14.4Mbps(DL)/5.76Mbps(UL) Data only DC Output: 5V/2A Input Voltage: 100 ~ 240VAC Input Frequency: 47 ~ 63Hz. Chicony: W12-010N3A, W12-010N3B W12-010N3C, W12-010N3D W12-010N3E AC-Adapter l l Dimension (mm) l 123 (W) x 201.5 (H) x 8.
