User Manual

26
1. Turn on the computer, when the text appears, press [Del] or
the [Delete] key until the system enters the BIOS Setup screen,
you may now make the necessary changes.
2. Press the è arrow key until it reaches the “ Exit” menu screen.
Again press the ê arrow key and select the “ Battery
Calibration” item.
Press the [Enter] key and disconnect the AC adapter then
press the [Y] key until you hear continuous battery low-low
warning beeping sounds.
The system will be fully discharge and shutdown completely.
3. Connect the AC adapter and let the battery fully recharge. The
“ Battery Charge LED” of the computer will light indicating it is
in charging status.
4. When the battery charge LED turns off will indicate the system
is fully charged.
5. Repeat step 1 to 4 once again.
6. The battery is now fully calibrated.
RESETTING THE SYSTEM
After installing a software application package, you may be
prompted to reset the system to load the changed operating
environment. To reset the system, or “reboot,” press the
[Ctrl]+[Alt]+[Delete] button. This is known as “warm boot.” This
key combination acts as “software” reset switch when you
encounter hardware or software problems, which lock up the
computer.
ADJUSTING THE BRIGHTNESS
To adjust the brightness on the LCD screen, use the brightness
adjustment button located at the right sides of the system. Press
on the + knob to increase and – knob to decrease the brightness of
your LCD display.