User's Manual

SystemSpec
Environmental
OperatingTemperature ‐20˚~55˚C 
Humidity 
5‐95%RHat25‐35˚C
(Non‐Condensation)
Chassis  IngressProtectionRatingIP67 
Certifications 
EMC  CE,FCC,NCC 
SafetyCertifications  UL,CB 
RFID
Frequency
(UHFBand) 
902to928MHzband
902.75~927.25MHz 
RFIDPower
Output
27.76dBm
Network
Service 
DHCP,HTTPS,SSH 
IPaddressing StaticandDynamic 
Firmware
Upgrade
Networkfirmwareupgradecapabilities
Security SecureBoot
Antenna  Model:PAA‐001,PANELAntenna(TNCType),8dBi
Cable:1.0m
Note:
1. A DC 24V power supply from device or sensor is necessary for the AI port.
2. If DO is designed to drive a relay, a diode must been applied to the relay’s coil side.
3. This product is intended to be supplied by an UL certified DC source rated 48 Vdc;
600mA. Tma 55 degree C minimum and output meets SELV, Non-hazardous
energy level, if need further assistance, please contact ECS for further information.
3 GWS-RFID RFID Reader