Manualshelf

User's Manual

ManualsBrandsELITEGROUP COMPUTER SYSTEMS ManualsElectronicsRFID Reader
17181920212223242526
3.4 LAN Configuration
The steps below are used to configure the local area networking (LAN) of GWB-QX/GWS-QX.
If you use a serial console, you might setup networking by manual. Otherwise the networking is workable.
Step 1. Check a network interface.
root@WR‐IDP‐B072:~#ifconfig
eth0Linkencap:EthernetHWaddrf4:4d:30:53:b0:72
inet6addr:fe80::f64d:30ff:fe53:b072/64Scope:Link
UPBROADCASTRUNNINGMULTICASTMTU:1500Metric:1
RXpackets:0errors:0dropped:0overruns:0frame:0
TXpackets:227errors:0dropped:0overruns:0carrier:0
collisions:0txqueuelen:1000
RXbytes:0(0.0B)TXbytes:76754(74.9KiB)
Interrupt:40Baseaddress:0xc000
loLinkencap:LocalLoopback
inetaddr:127.0.0.1Mask:255.0.0.0
inet6addr:::1/128Scope:Host
UPLOOPBACKRUNNINGMTU:65536Metric:1
RXpackets:1884errors:0dropped:0overruns:0frame:0
TXpackets:1884errors:0dropped:0overruns:0carrier:0
collisions:0txqueuelen:0
RXbytes:122028(119.1KiB)TXbytes:122028(119.1KiB)
Step 2. Enable a network interface, e.g. eth0.
root@WR‐IDP‐B072:~#ifconfigeth0up
17 GWS-RFID RFID Reader