User's Manual

3.3 Login
The system can be accessed and controlled via a Linux shell called 'console'. The users may invoke
Linux commands to configure something in the procedures of the following sections.
You should plug an usb-to-RS-232 with d’sub cable to USB port for a serial console. GWB-RFID/GWS-
RFID supports two kinds of chip drivers for the cables, FTDI and PL2303.
If using serial console or terminal emulator, the serial port settings are
Setting Value
Baud 115200
Parity No
Data Bit 8
Stop Bit 1
Flow Control No
If using secure shell (called SSH), it listens on eth0, the IP depend on DHCP assigned. The eth0 is the
RJ45 connector nearby the DC-In jack on PoE. The secure shell service is disabled by default. You
should enable it via a serial console first.
GWS-RFID RFID Reader 14