User's Manual

For example, if the message “Express protect error writing Drive x” is

displayed, the user has to change the write protect switch setting on the

memory card. To change the switch setting, (a) eject the card, (b) change

the switch setting, and (c) re-insert the card.

Always disconnect all telephone lines from the wall outlet before

servicing or disassembling this equipment. To reduce the risk of fire, use

only No. 26 AWG or larger telecommunication line cord.

Power Saving Modes

This section contains information on the Notebook’s power system,

including the AC Adapter, the battery system, recharging the battery, and

tips for conserving battery power.

The power system is comprised of two parts, the AC Adapter and the

battery system. The AC Adapter converts AC power from a wall outlet to

the DC power required by the computer.

The Battery Power System

A fully charged pack will provide approximately 2.5 hours (Prescott

2.8GHz CPU, power saving mode runs battery mark 4.0.1) of battery life

depending on your system configuration application it runs.

Before using the computer on battery power for the first time, check the

battery status icon on the Windows Toolbar to make sure the battery is

fully charged.

See Battery Status later in this section for a description and explanation of

the Windows Battery icon. Charging the battery takes about 4 hours to

charge when the system is in off state. If possible, always charge the

battery completely.

Removing the Battery Pack

To remove the battery pack from its compartment, please refer to Chapter

Three, Inserting and Removing the Battery Pack.

Preparing the Battery Pack for Use

Before using the battery pack for the first time, the Smart Battery IC

within the battery pack should be calibrated in order to get accurate

reporting of remaining battery life status.

To calibrate the battery pack follows the instructions below:

1. Insert the battery into the battery compartment and turn on the

Notebook. If the battery is completely without power go to the next

step.

Otherwise, let the battery run down until the battery low-low

warning beeps are heard. The system will automatically enter