User's Manual

screen. If the controls are turned too far down, the screen will be dark.

Problem 3: An incorrect date and time are displayed.

Solution3: Correct the date and time using the DOS DATE and TIME commands or the options in the

Setup Utility. If the date and time become incorrect after a short time, your CMOS battery may be

depleted. Contact your dealer to change the battery.

Problem 4: The message: “Invalid system disk, Replace the disk, and then press any key” appears

during boot.

Solution4: Check and make sure that you do not have a non-bootable floppy diskette inserted in your

CD-ROM. If your CD-ROM is empty, you may not have an operating system installed on your drive.

Contact technical support for assistance.

Problem 5: You hear irregular beeps during operation of the Notebook and the system halts.

Solution5: The problem is beyond the scope of this manual. Contact technical support.

Problem 6: An unidentified message is displayed.

Solution6: Reboot the computer and run the BIOS system setup. Confirm the Setup parameters. If the

same message is displayed after booting up again, contact technical support for assistance.

Problem 7: The system cannot access the CD-ROM/DVD-ROM drive.

Solution7: Check that a CD is properly inserted in the drive. Make sure that you are using the correct

program for that kind of CD. For example, the system cannot read a data CD using an audio program.

Problem 8: You cannot operate the printer.

Solution8: Check the printer cable connection. Ensure that the printer power switch is turned on.

Confirm that the printer is on-line.

Problem 9: You cannot use the mouse.

Solution9:

Ø Check the cable connection.

Ø Check the mouse with another application to see if there is a software incompatibility problem.

Ø If possible, check the mouse with another computer to see if it works. If it doesn’ t operate on a different

system, the mouse might be broken.