Product data

electric gate operators
section 02829
7. UL 312 and UL 991 Listed.
B. Chassis: 1/4 inch (6 mm) gold yellow zinc dichromate-plated steel chassis.
C. Operator Enclosure: High density polyethylene plastic with a stainless steel access door.
D. Operator Motor: 12V DC motor and plug-in transformer; provides up to 250 operating cycles
per day.
E. Operator Motor: 12V DC motor provides for varying number of operating cycles per day,
depending on available solar power.
1. Solar Power Supply: “Solar-3” 12V power system.
F. Battery Backup: SwingBarrier gate housing shall contain an integral and internally-mounted
battery backup system to automatically engage in the event of a power loss and auto-reset to
normal operation when power is restored; battery backup shall provide complete operation,
up to 50 cycles, of not only the gate operator, but all DC control devices and sensing devices,
including all sensing loops, to maintain normal operation of the swing barrier gate system in the
event of a power loss; battery charging shall be accomplished by an integral regulated battery
management system that maintains proper battery levels to insure no disruption in service in
the event of line power failure.
1. Battery: Provide 7-amp 12V DC battery.
G. Gear Reduction: Two gear reducers in synthetic oil bath.
H. Control Circuit: Microprocessor (RISC) electronics and solid-state control board; low-voltage
control inputs provide for connection of optional external devices including loop detectors,
access control systems, and radio receivers.
I. Additional Required Controls:
1. On-board plug in module Internally-mounted 312 HM radio receiver.
2. Inherent obstruction sensing allowing a closing gate to reverse to open and an opening
gate to stop, and reverse 2 seconds, and stop again.
3. Automatic Closing Timer: Timer-to-close providing adjustable timer settings between 0
and 60 seconds.
4. Alarm: Activates when moving gate is physically stopped by an obstruction.
J. Non-scissor swing aluminum arm designed to be free of pinch points and to bend when at
the break point if the gate encounters an obstruction.
K. Equipment: Provide optional remote controls.
L. Heater: Chamberlain / LiftMaster G6518CSW Self-regulating Heater Coil; keeps operator
gearbox and batteries at suitable temperature when outside temperature is below 0 degrees F
(-18 degrees C) for extended periods of time. Installs into the frame of the operator.