Product data

electric gate operators
section 02829
loops, to maintain normal operation of the swing barrier gate system in the event of a power
loss; gate(s) open on power failure when user selected on control board with a 15 second
delay; battery charging shall be accomplished by an integral regulated battery management
system that maintains proper battery levels to insure no disruption in service in the event of line
power failure.
1. Batteries: Provide two 7-amp 12V DC batteries per gate operator for battery backup
power.
G. Gear Reduction: Heavy-duty 900:1 gear reducer in synthetic oil bath.
H. Control Circuit: Microprocessor (RISC) electronics and solid-state control board; low-voltage
control inputs to provide for connection of a full range of optional external devices including
loop detectors, access control systems, and radio receivers.
I. Additional Required Controls:
1. Internally-mounted 312 HM radio receiver. Built in Security plus 2.0 radio for extended
range
2. Inherent obstruction sensing providing separate force adjustments for both open and
closed directions, allowing a closing gate to reverse to open and an opening gate to stop
and reverse 2 seconds.
3. Soft start/stop capabilities providing extended gate system life.
4. Dynamic electronic braking to provide gate position control and ensure consistent gate
closing without coasting.
5. Wireless or twisted pair Dual gate operation capabilities to allow two separate gate
operators to operate in unison at a single entrance.
6. Automatic Closing Timer: Timer-to-close providing adjustable timer settings between 1
and 33 90 seconds.
7. MyQ and Gate Monitor wireless accessory compatible
8. Dual gate operation 2-wire or wireless control system that provides for the operation of
two separate gate operators in unison at a single entrance and also provides the ability
to connect accessories to either operator.
9. Non-scissor swing aluminum arm designed to be free of pinch points and to bend when
at the break point if the gate encounters an obstruction.
J. Equipment: Provide the following optional equipment.
1. Sequenced Access Management System providing ability to control a swing gate
operator in tandem with a barrier gate operator.
2. Dual Programmable output Aux relays (when expansion board connected).
3. Radio receivers.
4. Remote controls.
5. Heater model available kit:
a. 150 watt.
b. 500 watt.