Owner's Manual

Rev. 08/15/17-JA www.elitescreens.com 6
How to deprogram the RF remote and delete the code
3. Extended IR sensor: Plug the extended IR sensor into the port located on the left side of the screen’s end
cap. (see below image for precise port location)
Note: Cover will need to be opened to expose inputs
4. 5-12 volt trigger:Connect the mini jack plug end to the 5-12 volt trigger port (see
image above) and the other end to your projector’s output port to synchronize the
projector’s power cycle to your screen. Connection to the projector’s trigger port is not
included. Refer to the diagram below for wiring instructions. Contact your projector’s
manufacturer for proper 5-12 volt trigger cable information.
The screen should automatically DROP when the projector is turned ON and RETRACT
when the projector is turned OFF. You can test the operation using a 9-volt battery.
Press and hold the UP button
for more than 3 seconds.
Plug the screen’s power
cable into a power outlet.
Stop pressing the UP button upon
hearing a beeping sound. This indicates
you are in the programming mode.
Press the DOWN button
The receiver will
beep three times.
Code has been deleted and RF
remote is no longer operational
5-12 v trigger port
Extended
IR sensor
port
RS485 port