User Guide

V.7/29/15-JA www.elitescreens.com 6
How to deprogram the RF remote and delete the code
3. Extended IR sensor: Plug the extended IR sensor into
the port located on the left side of the screen’s lower part
next to the weight bar. (see below image for precise port
location)
4. 5-12 volt trigger:Connect the mini jack plug end to the 5-12 volt trigger port (see
image above) and the other end to your projector’s output port to synchronize the
projector’s power cycle to your screen. Connection to the projector’s trigger port is not
included. Refer to the diagram below for wiring instructions. Contact your projector’s
manufacturer for proper 5-12 volt trigger cable information.
The screen should automatically DROP when the projector is turned ON and
RETRACT when the projector is turned OFF. You can test the operation using a 9-volt
battery.
5. UP/DOWN manual control buttons (located on left side end cap)
Press and hold the UP button
for more than 3 seconds.
Plug the screen’s power
cable into a power outlet.
Stop pressing the UP button upon
hearing a beeping sound. This indicates
you are in the programming mode.
Press the DOWN button
The receiver will
beep three times.
Code has been deleted and RF
remote is no longer operational
Press and hold the UP button to retract the screen
Press and hold the Down button to deploy the screen
Front side of screen
Extended IR sensor port
5-12 v trigger port
RS232 port
Press the STOP button first on the
remote prior to using the manual
control buttons.