User Guide

Rev.011817-DR www.elitescreens.com 3

2. Unfold the frame until the latch on the hinge "clicks" into place. Repeat the procedure for the shorter

sections. (Fig. 5-6)

3. Make sure all 4 corners of the frame are at a 90° angle and the hinged support bar is straight and not

bending. (Fig. 7-9)

4．Insert the frame legs (B) into the openings located at the left and right bottom sides of the folding

frame (A). Secure them by fastening the knob screw (E) into the adjacent hole. Next, screw the eyebolts

(F) into the openings located at the top of the frame (Fig.10).

5. Take the screen material (D) out of the screen material bag (C) and align the corners of the screen

material with the inside corners of the frame. Unfold as shown in the diagram (Fig.11-12).

. Once the screen material (D) is fully extended, secure the material by snapping the buttons onto the

frame studs as shown in Fig. 13-15. Fasten the buttons in the following order AB→CD→EF→GH.

Fig.7

Fig.8

Fig.9

Fig. 12

Fig.11

Fig. 6

Fig. 5

Fig.10