User Guide

www.elitescreens.com [e-mail]
INSTALLATION H
A. Flush Wall Mounting (Hardware not included)
1. Mark the location of where the screen is to be installed and drill your holes.
2. Insert the proper screw and leave about 1/8" of an inch from the wall to mount the screen.
3. Mount your screen from the keyhole located on back of the screen’s left and right end cap.
Note: Do not remove the end caps to mount the screen to the wall. Removing the end caps will release the tension of
the internal spring mechanism
B. Ceiling Installation (Hardware not included)
1. Only screens with flanges (models: 128” – 170”) can be flush mounted to the ceiling by drilling
screws directly through the screw holes and in to the ceiling’s fixture. For D-ring installation to the
ceiling, please refer to option 2.
Optional installation method using chains to hang the screen from the ceiling:
2. You can hang the screen from the ceiling by using chains (not included) and hooking them to the D-
ring loops on models 71”-120” and 136S, which are located on each end of the housing. For models
128”-170”, U-bolts are required to create loops for hanging the screen with chains from the end
caps’ flanges.
Note: Please consult with a hardware store professional for proper screws for your specific wall or ceiling installation.
Hardware and U-bolts are not included with the manual screen.
Back of end cap
Front view
Side view
Models: 71”-120” and 136S
Models: 128”-170”
D-ring
Flange with a pair of screw holes