Warranty

3/6/2015 3
SCREEN OPERATION
Setup: Remove the controls and wiring from the compartment on the left side of the Kestrel Floor
Electric Screen as shown in the pictures below.
Connect the screen to the power supply and switch the power button on. Now it is ready for use.
Power:
About the Control System:
1. Wireless 5- 12V Trigger: The ZSP-TR02 Wireless 5- 12V trigger for your new Elite Kestrel allows your
screen to synchronize its rise and drop with the projectors power cycle by connecting the output trigger,
which is typically located on the back of most projectors, and the RF remote control via the ZSP-TR02
cable. The screen rises when the projector powers up and retracts when the projector powers down.
2. RF (Radio Frequency) and Optional IR (Infrared) Remotes: The Kestrel Series screen includes both
IR and RF receivers that enable the consumer to use either the RF or an optional IR remote control. The
RF remote is best used when the screen is concealed or long distance control is required. The RF
technology therefore more versatile as it does not require line of to operate the screen. The optional IR
requires a direct line of sight through the screen’s IR receiver window.
Controlling the Kestrel Series with the optional accessories: Wired 5-12V
trigger, Extended IR “eye” receiver or 3-way wall box switch-
1. Wired 5-12V Trigger: Connect the 5-12 volt trigger cable to your projector’s trigger output via a separate
cable that may or may not be provided by the projector manufacture. The trigger feature will not work without an
output cable from the projector, but it can be tested using a 9-volt battery by simply connecting the Red (+) and
Green (-) cable to the 9-volt battery
2. IR “Eye” Receiver: The IR “eye” receiver cable provides an extension of the IR sensor should
the IR receiver window on the Kestrel’s screen is concealed.
3. 3-way wall sw i t ch box: The 3-way wall switch box allows manual control to operate the screen’s
UP/STOP/DOWN commands.
ON OFF
IR receiver window