User Guide

11/29/2016 www.elitescreens.com 4

About the RF/IR Remote Controls:

The new remotes, included in this version of the Kestrel

Series, are touch sensitive remote controls. Please be sure

to place your finger directly in the center of the button when

attempting to control your screen. You will see a blue light

flash above the buttons when used properly.

Note: When operating your screen to open, the motor will automatically roll back and adjust to make sure

the fabric is properly tensioned as the screen raises to the suitable position.

Charging the RF/IR Remote Control:

Once charging is needed, plug the Micro USB Charge Cable into any USB power source and into the left

side of your RF or IR Remote Control. While charging, you will see a solid red light above the touch

sensitive buttons. For your convenience, you may use the remote while it charges.

Note: The red light may dim while charging.

Storing the screen:

Always store the screen flat horizontally. Never store the screen in a vertical position.

Screen Maintenance

1. Always close the screen when not in use

2. Do not touch the screen surface

3. Keep away from direct sun and high/low temperatures

4. For indoor use only

5. Clean with soft water

6. Do not drop/close screen consecutively for more than 3 minutes. This is to avoid overload protection

shut-off. If automatic shut-off occurs, please wait for 20-30 minutes to try again.

For local Elite Screens contact or Technical Support, please visit

www.elitescreens.com

Charge port

STOP

DOWN