User Guide

ManualsBrandsElite Screens ManualsHome Theater SystemsF84NWV

Rev101912-JA www.elitescreens.com 1

ezCinema Series

Portable Floor Pull-Up Screen

USER’S GUIDE

Precautions:

Warning! Screen damage can result from product mishandling if the following

precautions are not followed.

In accordance with practicing home fire safety and to avoid screen damage, do not place the

screen near or beside a fireplace or high temperature appliances such as a gas stove, BBQ or

heater. (Fig. 1)

Fig.1 Fig.2

Place the screen beyond the reach of children. (Fig.2)

Summary of content (7 pages)

PAGE 1
ezCinema Series Portable Floor Pull-Up Screen USER’S GUIDE Precautions: Warning! Screen damage can result from product mishandling if the following precautions are not followed. In accordance with practicing home fire safety and to avoid screen damage, do not place the screen near or beside a fireplace or high temperature appliances such as a gas stove, BBQ or heater. (Fig. 1) Fig.1 Fig.2 Place the screen beyond the reach of children. (Fig.2) Rev101912-JA www.elitescreens.
PAGE 2
PARTS IDENTIFICATION: For models 100”, 120”, 135” and 150” Pull hook Upper scroll bar Front Note: Second telescoping rod available on 150” models only.
PAGE 3
Setting up the screen Installation: The ezCinema screen is designed to be used as an easy to operate portable screen for a variety of presentation environments. Its design enables it to be versatile for use in either classroom, conference room, home or patio presentations. When packed, the unit carries with ease and opens up for projection presentations within seconds.
PAGE 4
Installing the support rod: First, make sure that the hanging hook is pointing toward the front facing the same direction as the screen, then insert the square end of the telescopic support rod into the support plate as shown below. Support Plate Pull up the screen: Hold the pull hook with one hand, pull the screen up gently and hang it on the bracket hook.
PAGE 5
Adjusting the screen: Hold the screen with the left hand when the screen has been stretched to the desired position, and then rotate the locking sleeve clockwise with the right hand until the telescopic rod is properly locked into position. Screen completely assembled Below diagrams just used for reference and may vary on your model. Preparing screen for storage 1.
PAGE 6
2. Retract the screen: Remove the pull hook from the support bracket by lifting it about 2 cm up and then hold on to the pull hook and lower the screen gently into the box. 3. Pulling out the telescopic support rod: After telescoping the small supporting rod to its shortest position and tightening the locking sleeve, take out the supporting rod from the support plate. 4.
PAGE 7
6. Storing the screen: The recommended place for storage would be a corner of the room or in a closet, but the ultimate choice is up to you. The following points should be noted to assure the sound performance of the screen 1. Never use your hand to touch the screen surface. 2. Never write on the screen with pens, pencils, markers, etc.. 3. Don't touch the screen with hard or sharp objects. 4. Please use a clean cotton cloth or soft dust brush to remove any dust particles on the screen. 5.