User Manual

Rev.060116-D
Evanesce B Series| Controls and Accessories
A. IR Remote
E. IR extended “eye” receiver
F. Wireless 5
mono
Screen Operation
Electric Current:
Depending upon region, your Elite Screen will operate on 100v, 110v, or 220v voltage.
1.After ensuring the power
outlet & screen are compatible (
2. Once the screen
has power, you’ll be able to control it using any of the 6 methods described below.
6 ways to control your Evanesce B
1. IR remote control (
Item A, Fig 1
): The Infrared functions by direct line
of sight contact with a beam range of 30 feet. Aim the IR remote at the
“eye” receiver once it has been connected to the control box’s RJ45 port.
2. IR “Eye” Receiver (Item E, Fig 2
): The IR “Eye” Receiver plug
directly into the control box’s RJ45
port
sight control option for your IR remote control even in a recessed ceiling
installation.
3. RF Remote Control (Item B
): The radio waves eliminate the need for a
direct line of sight wi
th a range of 100 feet.
4. 3-Way Wall Switch (
Item C, Fig 3
mount switch
with an up/stop/down button and plug
control box’s RJ45 port.
3 Way Wall Switch
(does not have IR sensor)
Control box
3
Evanesce B Series| Controls and Accessories
B. RF Remote C. Wall switch control box
D. 5
F. Wireless 5
-12v (3.5 mm)
mono
trigger cable
G. AAA batteries
Depending upon region, your Elite Screen will operate on 100v, 110v, or 220v voltage.
outlet & screen are compatible (
voltage), plug
the power cord into the poweroutlet.
has power, you’ll be able to control it using any of the 6 methods described below.
): The Infrared functions by direct line
of sight contact with a beam range of 30 feet. Aim the IR remote at the
“eye” receiver once it has been connected to the control box’s RJ45 port.
): The IR “Eye” Receiver plug
s
port
to present a low profile line-of-
sight control option for your IR remote control even in a recessed ceiling
): The radio waves eliminate the need for a
th a range of 100 feet.
Item C, Fig 3
): The 3-way wall switch is a wall
with an up/stop/down button and plug
s directly into the
Fig.3
IR “eye” receiver
(does not have IR sensor)
Control box
www.elitescreens.com
D. 5
-12 volt trigger cable
H. Bubble leveler
Depending upon region, your Elite Screen will operate on 100v, 110v, or 220v voltage.
the power cord into the poweroutlet.
has power, you’ll be able to control it using any of the 6 methods described below.
UP
STOP
DOWN
Fig.1
IR/RF remote
IR “eye” receiver
Fig.2